, sometimes suggesting that CLI-only configuration is necessary to bypass the broken web interface. Recommendation

a specific access point from Lightweight to Autonomous, or are you trying to fix a broken web interface on your current setup?

If you are converting from a Lightweight image to this Autonomous one, you typically use the ROMMON recovery method or the CLI: Cisco Community Preparation : Set up a TFTP server on your laptop and place the file in the root directory. CLI Command

archive download-sw /overwrite tftp://[IP_ADDRESS]/ap3g2-k9w7-tar.153-3.jf15.tar

(requires WPA2/AES or no encryption) and bridging capabilities. Default Credentials: For fresh installations of this firmware, the default login is usually Cisco / Cisco (case-sensitive). Default IP: If no DHCP is available, the AP may default to after a factory reset. Essential Deployment Tips Web Gui problem - Page 2 - Cisco Community

: For a bricked or "stuck" AP, you can interrupt the boot process to set manual IP variables and use to pull the image. Cisco Community Are you planning to

: If you encounter issues, consider looking for a more stable or later release, such as 15.3(3)JPQ4